LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 415 (Engine Mechanical - 8.1L V8) >> Removal & Installation >> Camshaft Bearing >> Installation

Camshaft Bearing: Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Suburban, and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the tool handle, expanding driver, and washer.
  2. Insert the camshaft bearing service set tool into engine block end camshaft bearings.
  3. Drive the end bearings into the bore.
  4. Select the expanding driver and washer from the camshaft bearing service set and assemble the tool.
  5. Insert the camshaft bearing service set tool through the front of engine block and to inner bearing bores.
  6. Install bearing onto the expanding driver.
  7. Tighten the expander assembly nut until the tool is snug in the bearing.
  8. Align the oil lubrication hole in the bearing with the oil galleries in engine block.
  9. Push the guide cone into the front camshaft bearing bore to align the tool.
  10. Drive bearing into bore.
scientia non olet · About LEMON Manuals