LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 406 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Secondary Camshaft Timing Sprocket Replacement - Right Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the right secondary camshaft timing components in the following order:
    1. 1.1. Align the intake sprocket drive pin (1) between the two darkened links (2).
    2. 1.2. Align the exhaust sprocket drive pin (4) with the single darkened link (3).
    3. 1.3. Slide the exhaust camshaft sprocket onto the camshaft aligning the drive pin into the camshaft notch.
    Fig 1: Identifying Right Secondary Camshaft Timing Components Position
    G01816795Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the exhaust camshaft sprocket bolt.

    Tighten 

    1. 2.1. Tighten the camshaft sprocket bolt to 25 N.m (18 lb ft).
    2. 2.2. Use the J 36660-A  in order to tighten the camshaft sprocket bolt an additional 45 degrees.
    Fig 2: Installing Exhaust Camshaft Sprocket Bolt
    G01816796Courtesy of GENERAL MOTORS CORP.
  3. Remove the locking wire (2) from the right secondary drive chain tensioner (1) allowing the tensioner shoes to expand and apply pressure to the drive chain.
    Fig 3: Removing Locking Wire From Right Secondary Drive Chain Tensioner
    G01816797Courtesy of GENERAL MOTORS CORP.
  4. Remove the J 42038  from the right camshafts.
  5. Install the right camshaft cover. Refer to Camshaft Cover Replacement - Right .
    Fig 4: Removing J 42083
    G01816798Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals