LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 406 (Engine Mechanical - 3.5L (On-Vehicle)) >> Repair Instructions >> Oil Pump Pipe and Screen Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the new O-ring seal on the tube end is in place.
  2. Press the tube end into the oil pump.
    CAUTION: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the oil pump pick-up tube bolt (4) into the oil pump.

    Tighten 

    Tighten the oil pump pick-up tube bolt to 10 N.m (89 lb in).

    4. Fig 1: Installing Oil Pump Pipe & Screen
    G01816961Courtesy of GENERAL MOTORS CORP.
  4. Place the tab on the stud end main bearing bolt.
  5. Install the oil pump pick-up tube nut (2) on the stud.

    Tighten 

    Tighten the oil pump pick-up tube nut to 10 N.m (89 lb in).

  6. Install the oil pan. Refer to Oil Pan Replacement .
scientia non olet · About LEMON Manuals