DTC P1125: Accelerator Pedal Position Sensors Out Of Range Or Disagree: Description
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The Accelerator Pedal Position (APP) sensor is mounted on the accelerator pedal control assembly. The sensor is made up of 3 individual sensors within one housing. Three separate signals, low reference, and 5-volt reference circuits are used in order to interface the APP sensor with the ECM. Each sensor has a unique functionality to determine pedal position. See APP SENSOR POSITION . The Engine Control Module (ECM) uses the APP sensor to determine the amount of acceleration or deceleration desired by the person driving the vehicle via fuel injector control. This Diagnostic Trouble Code (DTC) sets if the ECM detects a condition with more than one sensor within the APP sensor.
APP SENSOR POSITION
| APP Sensor | Actual Pedal Position | % Depressed As Observed On Scan Tool | Voltage As Observed On Scan Tool |
|---|---|---|---|
| 1 | Pedal At Rest | 0 | 0.52-0.80 |
| 1 | Pedal At Full Travel | 100 | 2.12-2.78 |
| 2 | Pedal At Rest | 0 | 4.25-4.53 |
| 2 | Pedal At Full Travel | 100 | 2.24-2.93 |
| 3 | Pedal At Rest | 0 | 3.95-4.13 |
| 3 | Pedal At Full Travel | 100 | 2.69-3.16 |