LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Automatic Transaxle Overhaul & Testing - 4T65-E) >> Component Disassembly & Reassembly >> Input, 2ND, 3RD & Sprag Clutches >> Reassembly

Input, 2ND, 3RD & Sprag Clutches: Reassembly

WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2003 Pontiac Montana, 2003 Pontiac Grand Prix, 2003 Pontiac Bonneville, 2003 Pontiac Aztek, and 2003 Oldsmobile Silhouette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install selective thrust washer and thrust bearing assembly onto input clutch housing assembly. See Figure. Using small screwdriver, align 2nd clutch teeth. Install 2nd clutch housing assembly onto 2nd clutch hub of input clutch housing assembly.
  2. Install Final Drive/Clutch Remover/Installer (J-33381-A) into 2nd clutch housing and input clutch housing. Sprag clutch assemblies will also be attached. See Figure. Tighten threaded rod until rod is finger tight.
scientia non olet · About LEMON Manuals