LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 377 (Engine Controls - Removal & Installation - Flex Fuel & Gasoline) >> Sensors >> Crankshaft Position Sensor >> Removal (4.3L)

Removal (4.3L)

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Crankshaft Position (CKP) sensor variation learn procedure will need to be performed whenever CKP sensor is removed or replaced. See CKP SYSTEM VARIATION LEARN PROCEDURE  under programming.
  1. Turn ignition off. Raise and support vehicle. Remove steering linkage shield bolts and steering linkage shield (if equipped).
  2. Disconnect Crankshaft Position (CKP) sensor harness connector. CKP sensor harness connector is located on front of engine, behind crankshaft pulley. See Figure. Remove CKP sensor mounting bolt and CKP sensor.
scientia non olet · About LEMON Manuals