DTC P1125: Accelerator Pedal Position Sensors Out Of Range Or Disagree: Description

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The Accelerator Pedal Position (APP) sensor is mounted on the accelerator pedal assembly. The sensor is actually 3 individual APP sensors within 1 housing. There are 3 separate signal, low reference, and 5-volt reference circuits are used in order to connect the APP assembly and the Throttle Actuator Control (TAC) module. If only one APP sensor DTC is set, the redundant APP systems allow the TAC system to continue operating normally. This DTC sets if the Powertrain Control Module (PCM) detects a condition with more than one APP sensor. One APP sensor DTC will not cause the Reduced Engine Power message to be displayed. If there are 2 APP sensor DTCs for the same sensor, it will not cause the Reduced Engine Power message to be displayed. However, if 2 or more DTCs are set involving more than 1 APP sensor, this DTC will set and the Reduced Engine Power message is displayed.