LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Manual Transmission Clutches) >> Removal & Installation >> Clutch Pedal Replacement

Clutch Pedal Replacement

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driver's side knee bolster and deflector. Disconnect and reposition the junction block. Disconnect the clutch pedal position switch electrical connector. Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal.
  2. Disconnect the clutch master cylinder to clutch actuator cylinder quick connect fitting. Remove the clutch master cylinder clip from the brake pressure module valve pipe.
    3. NOTE: Complete removal of the clutch master cylinder is not required.
  3. Rotate the clutch master cylinder 45 degrees clockwise to the unlocked position. Pull the clutch master cylinder out until the pushrod socket is not touching the clutch pedal. Remove the clutch pedal to clutch pedal bracket bolt. Remove the clutch pedal to brake module bolts. Remove the clutch pedal sub-assembly. To install, reverse removal procedure. Torque all fasteners to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals