LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Rear Suspension System) >> Removal & Installation >> Shock Absorber (Sierra & SILVERADO) >> Removal

Shock Absorber (Sierra & SILVERADO): Removal

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Support rear axle.
  3. Disconnect the electrical connector if equipped with Selectable Ride.
  4. Remove the upper shock absorber nut and bolt. See Fig 1 .
  5. Remove the lower shock absorber nut and bolt.
  6. Remove the shock absorber. To dispose of shock absorber, see SHOCK ABSORBER DISPOSAL  .
Fig 1: Removing & Installing Shock Absorber (Sierra & Silverado)
G00136220Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals