LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Rear Suspension System) >> Removal & Installation >> Shock Absorber (15 Series Utility Without Level Control) >> Removal

Shock Absorber (15 Series Utility Without Level Control): Removal

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect the electrical connector and air line if equipped with Real Time Damping (RTD). See Fig 1 .
  3. Support the rear axle.
  4. Disconnect the Real Time Damping (RTD) sensor harness connector from the vehicle harness connector (if equipped).
  5. Remove the upper shock absorber nut and the bolt. See Fig 2 .
  6. Remove the lower shock absorber nut and the bolt.
  7. Remove the shock absorber. To dispose of shock absorber, see SHOCK ABSORBER DISPOSAL  .
Fig 1: Disconnecting & Connecting Electrical Connectors & Air Line (15 Series Utility Without Level Control)
G00136221Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Shock Absorber (15/25 Series Utility Without Level Control Shown; Other Applications Similar)
G00136224Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals