Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Apply sealant GM P/N 12345739 (Canadian P/N 10953472) or equivalent at the cylinder head to lower intake manifold joint.
- Apply sealant at the cylinder head to lower intake manifold joint at the rear of the lower intake manifold (1).
- Apply sealant at the cylinder head to lower intake manifold joint at the front of the lower intake manifold (1).
- Install a new right valve rocker arm cover gasket.
- Install the right valve rocker arm cover.
- Install the right valve rocker arm cover bolts.
Tighten:
Tighten the bolts to 10 N.m (89 in lbs)
- Install the vacuum hose to the grommet in the right valve rocker arm cover.
- Install the ignition coil bracket studs.
- Install the ignition coil bracket with the coils. Refer to IGNITION COILS .
- Install the EVAP purge valve. Refer to EVAPORATIVE EMISSION (EVAP) CANISTER PURGE VALVE REPLACEMENT in ENGINE CONTROLS - REMOVAL & INSTALLATION, OVERHAUL
- Install the right spark plug wires. Refer to SPARK PLUG WIRE REPLACEMENT in ENGINE CONTROLS - REMOVAL & INSTALLATION, OVERHAUL .
- Install the generator bracket.
- Install the generator. Refer to GENERATOR .
- Install the drive belt. Refer to Drive Belt Replacement .
- Connect the negative battery cable.
- Inspect for leaks.