LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 344 (Automatic Transmission Removal & Installation) >> Removal & Installation >> Transmission Support >> Removal (4WD)

Removal (4WD)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, 2003 Chevrolet Blazer, and 2002 GMC Sonoma. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Install the transmission jack-to-transmission and support the transmission.
  3. Remove the transmission wiring harness from the transmission support, if necessary.
  4. Remove the transmission mount-to-transmission support stud nuts. See Fig 2.
  5. Remove the catalytic converter hanger bracket, if necessary, from the transmission support.
  6. Remove the transmission support to the frame nuts and bolts. See Fig 1.
  7. Remove the transmission support.
Fig 1: Removing/Installing Transmission-To-Vehicle Support
G00207810Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Transmission Mount-To-Transmission Support Stud Nuts
G00207819Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals