LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Power Door Lock System & Trunk Release) >> Removal & Installation >> Door Trim Panel >> Removal & Installation (Impala)

Removal & Installation (Impala)

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place window in full down position. Remove screw from inside door handle bezel. Pull inside door handle bezel away from door trim panel. Disconnect power door lock switch harness connector. Remove inside door handle bezel. Remove screws from armrest pull cup. Insert flat-blade tool under front edge of armrest pull cup to release clip. Disconnect harness connectors from switches and remove armrest pull cup.
  2. Remove trim panel screws from armrest pull cup support bracket. Remove 2 screws from door pull handle bracket (front door). Using Door Trim Panel Retainer Remover (J-38778), release door trim panel retainers. Remove upper door trim panel retaining screw, located at "A" pillar (front door). Remove door trim panel. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals