Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari, 2002 Chevrolet Astro, 2001 GMC Safari, and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Install the seat back recliner to the seat frame.
Install the seat back bolts that retain the recliner to the seat back and the seat cushion frame. See Figure.
CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the seat back bolts in the locations noted during disassembly.
Tighten

Tighten the seat back bolts that retain the recliner to the seat back and the seat cushion frames to 30 N.m (22 ft lbs).
Install the screw that retains the seat back recliner handle to the seat back recliner.
Tighten

Tighten the screw that retains the seat back recliner handle to the seat back recliner to 2 N.m (18 in lbs).
Install the J-hooks that retain the carpet to the seat back and to seat cushion frame and to the corners of the seat cushion cover.
Install the armrest to the seat back recliner side of the seat. Refer to Armrest Replacement (YC7) or Armrest Replacement (YC6) .
Install the bucket seat to the riser. Refer to Seat Replacement - Bucket .