LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Seat System) >> Repair Instructions >> Seat Back Recliner Replacement - Front (YC5, YC6) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari, 2002 Chevrolet Astro, 2001 GMC Safari, and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the recliner to the seat back frame.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the bolts that retain the recliner to the seat back frame. Install the bolts in the locations noted during removal.

    Tighten 

    Tighten the bolts that retain the recliner to the seat back frame to 30 N.m (22 ft lbs).

  3. Refit the seat back cover and pad over the bolts that retain the recliner to the seat back frame.
  4. Install the armrests, if equipped. Refer to Armrest Replacement (YC7)  or Armrest Replacement (YC6)  .
  5. Install the bolts that retain the recliner to the seat cushion frame. See Figure. Install the bolts in the positions from which they were removed, as noted during disassembly.

    Tighten 

    Tighten the bolts that retain the recliner to the seat cushion frame to 30 N.m (22 ft lbs).

  6. Install the seat cover J-hooks to the seat cushion frame as follows:
    1. Install the J-hook that retain the seat cover to the carpet on the back of the recliner side of the seat.
    2. Install the J-hook to the seat frame on the recliner side of the seat.
    3. Install the J-hook at the rear of the seat.
  7. Install the screw that retains the recliner handle to the recliner.

    Tighten 

    Tighten the screw that retains the recliner handle to the recliner to 2 N.m (18 in lbs).

  8. Install the bucket seat to the riser. Refer to Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals