LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Seat System) >> Repair Instructions >> Seat Back Hinge Trim Replacement - Rear Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari, 2002 Chevrolet Astro, 2001 GMC Safari, and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper seat back hinge cover as follows:
    1. Align the fasteners with the hinge.
    2. Press the lower seat back hinge cover into place. See Figure.
  2. Install the lower seat back hinge cover as follows:
    1. Align the fasteners with the hinge.
    2. Press the upper seat back hinge cover into place. See Figure.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the lower seat back hinge cover retaining screw.

    Tighten 

    Tighten the lower seat back hinge cover retaining screw to 2 N.m (18 in lbs).

  4. Install the rear bench seat to the vehicle. Refer to Seat Replacement - Rear Bench (2001)  or Seat Replacement - Rear Bench (2002)  .
scientia non olet · About LEMON Manuals