Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Safari, 2002 Chevrolet Astro, 2001 GMC Safari, and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Install the seat back hinge to the seat back frame.CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the bolts retaining the seat back hinge to the seat back frame. See Figure. Install the bolts in the locations noted during disassembly.
Tighten
Tighten the bolts retaining the seat back hinge to the seat back frame to 30 N.m (22 ft lbs).
- Install the armrests, if equipped. Refer to Armrest Replacement (YC7) or Armrest Replacement (YC6) .
- Install the bolts that retain the seat back hinge to the seat cushion frame. Install the bolts in the locations from which they were removed, as noted during disassembly.
Tighten
Tighten the bolts that retain the seat back hinge to the seat cushion frame to 30 N.m (22 ft lbs).
- Install the seat cushion J-hook to the seat cushion frame as follows:
- Install the J-hook that retains the seat cover to the carpet on the back of the seat on the side of the seat containing the recliner.
- Install the J-hook to the seat frame on the side of the seat containing the seat back hinge.
- Install the J-hook to the rear of the seat back.
- Install the bucket seat to the riser. Refer to Seat Replacement - Bucket .