LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Rear (YC7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari, 2002 Chevrolet Astro, 2001 GMC Safari, and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back frame. See Figure.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the bolts that retain the seat back frame to the seat back hinges in the locations noted during disassembly. See Figure.

    Tighten 

    Tighten the bolts that retain the seat back frame to the seat back hinges to 30 N.m (22 ft lbs).

  3. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear (YC5 and YC6)  or Seat Back Cover and Pad Replacement - Rear (YC7)  .
  4. Install the bench seat in the vehicle. Refer to Seat Replacement - Rear Bench (2001)  or Seat Replacement - Rear Bench (2002)  .
scientia non olet · About LEMON Manuals