LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Seat System) >> Repair Instructions >> Seat Adjuster Mechanism Replacement - Power >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Safari, 2002 Chevrolet Astro, 2001 GMC Safari, and 2001 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat trim panel L bracket flanges between the adjuster and the seat. Ensure that the holes in the L bracket flanges are indexed with the fastener holes on the adjuster and the seat.
  2. Connect the electrical connector on the back of the power seat switch. See Figure.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the 4 bolts that retain the adjuster to the seat.

    Tighten 

    Tighten the bolts that retain the adjuster to the seat to 30 N.m (22 ft lbs).

  4. Position the riser to the adjuster.
  5. Install the 8 nuts that retain the riser to the adjuster.

    Tighten 

    Tighten the nuts that retain the adjuster to the seat to 9 N.m (7 ft lbs).

  6. Install the seat to the vehicle. Refer to Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals