LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Wheel Alignment Specifications & Adjustment Procedures) >> Wheel Alignment Procedures >> Camber & Caster Adjustment >> "C", "G" & "K" Series (Frame Bracket Slot Removal)

"C", "G" & "K" Series (Frame Bracket Slot Removal)

WARNING: This page does not describe the selected car, but rather 64 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle with a jack (or jackstand) under each lower control arm. Remove wheel. Remove nuts, cams, and bolts from frame brackets at upper control arm. See Figure .
  2. Lift control arm upward and set it aside. Note perforations at bolt hole in each frame bracket. If a protective wax coating is covering perforations, remove wax. Assemble Knockout Remover (J-38794) on frame brackets. See Figure . Limited clearance may require that you remove the knockout from the outside inward (opposite of direction indicated in illustration).
  3. The head of the "T" bolt and the channel of the bridge must be horizontal, aligned with knockout. Turn nut until knockout breaks loose, but do not exceed 75 ft. lbs. (102 N.m) of torque. If more torque is required, stop procedure and remove knockout with a die grinder.
  4. Set control arm into position. Install bolts, cams, and nuts. Go to adjustment procedure.
scientia non olet · About LEMON Manuals