LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Removal & Installation >> Wiring Harness >> Installation

Wiring Harness: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the tabs (8) on the new wiring harness "U" channel with the solenoid retainer slots for solenoids "E" (3) and "D" (2) on the control valve assembly. Install the solenoid retainers (14) for the "E" (3) and "D" (4) solenoids. See Figure .
    NOTE: The internal wiring harness connectors (7) and (9-13) should be in the correct position for installation because of their pre-assembled position in the "U" channel.
  2. Attach the internal wiring harness connectors to their respective solenoids "A" through "F" and to the pressure switch assembly as follows:
    • Connector No. 13 - Solenoid No. 6. See Figure .
    • Connector No. 12 - Solenoid No. 4.
    • Connector No. 7 - Solenoid No. 5.
    • Connector No. 10 - Solenoid No. 2.
    • Connector No. 11 - Solenoid No. 3.
    • Connector No. 9 - Solenoid No. 1.
  3. Push the main transmission connector (2) outward through hole (1) in the main housing until the retaining "feet" on the connector are near the locked position. Figure .
  4. Use the internal wiring harness installer to seat the retaining "feet" on transmission connector (1). See Figure .
  5. Install the oil pan and suction filter. See INTERNAL FILTER  under LUBRICATION.
  6. Connect the external wiring harness to the main transmission connector.
scientia non olet · About LEMON Manuals