LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Removal & Installation >> Selector Shaft Seal >> Removal

Selector Shaft Seal: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Tools required: Selector Shaft Seal Remover (J-43911), and Selector Shaft Seal Installer (J-43909).
  1. Remove the PNP Switch. See PARK/NEUTRAL POSITION SWITCH  .
  2. Ensure the jackscrew for the selector shaft seal remover is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the selector shaft (2) with the threaded end of the tool towards the seal. See Fig 1 .
  3. Rotate the removal tool so the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to ensure the removal tool is firmly attached to the seal shell.
  4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Fig 1: Removing Selector Shaft Seal
G00096122Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals