LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Removal & Installation >> Selector Shaft Seal >> Installation

Selector Shaft Seal: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully slide a new selector shaft seal (1) over the selector shaft (2) with the wide face of the steel case facing outward. Position the seal so it is starting to enter the seal bore.
  2. Obtain the selector shaft seal installer and remove the inner sleeve so the tool will slide over the selector shaft. See Fig 1 .
  3. Slide the selector shaft seal installer into position so the end of the tool contacts the seal being installed.
  4. Use a mallet to strike the selector shaft seal installer and drive the new seal into the seal bore until it is seated at the bottom of the bore.
  5. Install the PNP Switch. See PARK/NEUTRAL POSITION SWITCH  .
Fig 1: Installing Selector Shaft Seal
G00096123Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals