LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Automatic Transmission Servicing - ALLISON LCT 1000) >> Removal & Installation >> Selector Shaft & Detent Lever >> Installation

Selector Shaft & Detent Lever: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, 2004 Chevrolet Cab & Chassis Silverado, and 2003 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the new detent lever (4) in position in the main housing. Rotate the detent lever to engage the park pawl apply assembly (2). Reinstall the selector shaft (5) through the selector shaft seal and through the detent lever (4). See Figure .
  2. Place the nut (1) in position over the selector shaft. Push the selector shaft (5) into its final position in the main housing. Reinstall the spring pin (3) into the main housing that retains the selector shaft.
  3. Install pin to 0.33-0.35" (8.5-9.0 mm) above main housing surface. Hand tighten nut (1). Tighten the nut (1) to specification. See TORQUE SPECIFICATIONS  .
  4. Install the PNP switch. See PARK/NEUTRAL POSITION SWITCH  .
  5. Install the control valve assembly. See CONTROL VALVE BODY  .
scientia non olet · About LEMON Manuals