Removal & Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Disable air bag system. Disconnect negative battery cable. Remove fasteners and push in retainers, holding lower right dashboard insulator panel to dashboard. Turn air temperature sensor 1/4 turn counterclockwise to remove from insulator panel. Disconnect harness connector from lower instrument panel courtesy light. Slide insulator panel to rear and remove from vehicle.
- Pull carpet back near Blower Motor. Remove 4 screws that hold glove box door to instrument panel. Pull toward rear on glove box door and remove door. Remove fasteners that secure glove box door to glove box. Remove Dashboard Integration Module (DIM) from bracket and position to side. Remove rear DIM bracket screws and lower bracket far enough to gain access to Blower Motor.
- Disconnect harness connector from Blower Motor. Disconnect vent tube if applies. Remove 6 Blower Motor retaining screws. Lower Blower Motor and rotate it clockwise to remove it from vehicle. To install, reverse removal procedure.