LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Removal & Installation >> Shift Cable >> Installation

Shift Cable: Installation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure that the transmission manual shaft lever is in the mechanical Park position.
  2. Align and install the cable to the bracket.
  3. Install the range selector cable end (2) to the transmission range selector lever ball stud (1). See Figure .
  4. Install the cable clip on the transfer case, if equipped.
  5. Install the retainer that secures the cable to the bracket. See Figure .
  6. Install the clips on the cable to the floor panel reinforcement. See Figure .
  7. Lower the vehicle.
  8. Install the cable grommet to the floor panel. See Figure .
    NOTE: Avoid unnecessary twisting/bending of the range selector cable when installing the cable to the support.
  9. Install the range selector cable to the support. See Figure .
  10. Install the bolt securing the cable support to the brace. See Figure . Tighten the bolt to specification. See TORQUE SPECIFICATIONS  .
  11. Install the cable to the steering column bracket. See Figure .
  12. Ensure the tangs fully seat (snap) into the steering column bracket.
  13. Install the cable end to the steering column ball stud.
  14. Install the retainer securing the cable to the steering column. See Figure .
  15. Position the carpet and insulation around the driver's area.
  16. Install the driver's seat.
  17. Install the instrument panel knee bolster.
  18. Test the transmission for proper shift operation.
  19. If all of the gear positions cannot be achieved, adjust the cable.