LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 275 (Automatic Transmission - 4L60-E/4L65-E - Servicing) >> Removal & Installation >> Control & Shift Solenoids >> Installation

Control & Shift Solenoids: Installation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 GMC Sierra, 2004 Chevrolet Tahoe, and 2004 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the 3-2 control solenoid. Install the 3-2 control solenoid retainer. Install the 1-2 and 2-3 shift control solenoids. See Figure .
  2. Install the 1-2 and 2-3 shift control solenoid retainers. Install the pressure control solenoid. Ensure the electrical tabs are facing outboard. See Figure .
  3. Install the pressure control solenoid retainer and retaining bolt and tighten to specification. See TORQUE SPECIFICATIONS  .
  4. Connect the internal wiring harness electrical connectors to the following components:
    • Transmission fluid pressure switch. See Figure .
    • 1-2 shift control solenoid.
    • 2-3 shift control solenoid.
    • Pressure control solenoid.
    • TCC PWM solenoid.
    • 3-2 control solenoid.
  5. Install the 1-2 accumulator. See ACCUMULATOR ASSEMBLY  .
  6. Install the transmission oil pan and filter. See DRAINING & REFILLING  under LUBRICATION.
  7. Fill transmission with appropriate fluid to proper level. See LUBRICATION  .
scientia non olet · About LEMON Manuals