LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 274 (Engine Controls - Self-Diagnostics - 2.2L) >> Diagnostic Tests >> DTC P1670: Driver 4 >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
  2. Is DTC P0562 set? If yes, go to DTC P0562: ECM DETECTS AN EXCESSIVELY LOW SYSTEM VOLTAGE . If no, go to next step.
  3. Observe the General Info - Output Data List with a scan tool. Do any parameters indicate a fault present? If yes, go to next step. If no, go to step  5.
  4. Test for a short to voltage on the control circuit of the component that indicated a fault. Did you find and correct the condition? If yes, go to step  6. If no, go to next step.
  5. Turn ignition off. Replace ECM. Perform ECM relearn procedure. See ELECTRONIC CONTROL MODULE REPROGRAMMING  under PROGRAMMING. After replacing ECM, go to next step.
  6. Using scan tool, clear DTCs. Turn ignition off for 30 seconds. Operate vehicle within the conditions for running the DTC. See CONDITIONS FOR RUNNING DTC . You may also operate vehicle within the conditions observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition? If yes, go to step  2. If no, go to next step.
  7. With a scan tool, observe the stored information, Capture Info. Does the scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals