LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 272 (Drive Axles - QUADRASTEER) >> Removal & Installation >> Axle Shaft & Seal - Inner >> Installation

Axle Shaft & Seal - Inner: Installation

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 Chevrolet Tahoe, and 2003 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Required Tools, J 33049 Camshaft Bearing Service Set and J 45177 Differential Seal Installer - Inner

  1. Assemble the drive bar extension onto the drive bar of J 33049.
  2. Insert the J 33049 into the opposite side axle shaft tube.
  3. Install the J 45177 onto the J 33049.
  4. Insert the axle shaft seal into the axle tube.
  5. Install the J 45177 (1) and the J 33049 (2) over the axle shaft seal.
  6. Drive the axle shaft seal into the axle tube using the J 45177 , the J 33049 and a hammer.
  7. Install the differential assembly.
  8. Install the axle shafts.
  9. Install the tire and wheel assembly.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals