LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Drive Axles - Full Floating Axle) >> Removal & Installation >> Hub & Rotor Assembly >> Installation

Hub & Rotor Assembly: Installation

WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 GMC Sierra, 2002 GMC Savana Special, and 2002 GMC Savana Camper Special. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lightly oil top of axle shaft tube. Install hub and rotor assembly onto axle shaft tube. Ensure inner bearing and oil seal are correctly installed.
  2. Install lubricated outer bearing. Install washer (if equipped) and adjusting nut. Using torque wrench and socket (J-2222-C), snug-tighten adjusting nut. To set wheel bearing preload, rotate hub and rotor assembly while tightening inner adjusting nut to 52 ft. lbs. (70 N.m).
  3. Stop turning hub. Back off adjusting nut clockwise until the nut contacts the bearing cone. Torque on the nut must be zero to finger tight. Align slots in nut and axle groove.
  4. Install locking tang washer and outer lock nut. Tighten lock nut to specification. See TORQUE SPECIFICATIONS  . Bend minimum of 2 locking tangs into notches of outer lock nut. Install axle shaft. See AXLE SHAFTS  . Install brake caliper. Install wheel/tire assembly. See TORQUE SPECIFICATIONS  . Add lubricant. See LUBRICATION  .
scientia non olet · About LEMON Manuals