LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Disc Brakes) >> Removal & Installation >> Master Cylinder Reservoir >> Removal

Master Cylinder Reservoir: Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply the park brake and block the wheels.
  2. Remove the master cylinder. See MASTER CYLINDER .
  3. Drain the master cylinder reservoir.
  4. Secure the master cylinder in a vise. Do not clamp the master cylinder body, secure only at the flange.
  5. Remove the brake fluid level sensor by carefully depressing the retaining tabs and pushing the sensor through the reservoir.
  6. Carefully remove the reservoir retaining pins. See Fig 1.
  7. Remove the reservoir from the master cylinder by pulling the reservoir straight up and away from the cylinder. See Fig 2.
  8. Remove the seals from the master cylinder.
Fig 1: Removing Reservoir Retaining Pins
G00310175Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Master Cylinder Reservoir
G00076377Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals