LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Disc Brakes) >> Removal & Installation >> Brake Rotor >> Installation (Rear - 4-Wheel Steering)

Installation (Rear - 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Whenever the brake rotor has been separated from the wheel bearing flange, clean any rust or foreign material from the mating surface of the rotor and flange with the J-42450 hub cleaning kit. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.
  1. Use the Wheel Hub Resurfacing Kit (J-42450-A) to clean all rust and contaminants from the mating surface of the hub flange.
  2. Use the Rotor Resurfacing Kit (J-41013) to clean all rust and contaminants from the inside diameter of the hat section of the brake rotor to prevent any foreign material from getting between the brake rotor and the hub flange.
  3. Install the rotor by slowly turning the rotor while pushing the rotor towards the axle. See Figure.
  4. Install the brake caliper and the brake caliper mounting bracket as an assembly to the vehicle.
  5. Perform the following procedure before installing the 2 brake caliper bracket mounting bolts:
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolts with brake parts cleaner or the equivalent and allow to dry.
    • Apply Threadlocker (GM P/N 12345493) to the threads of the bolts.
  6. Install the 2 brake caliper bracket mounting bolts. See Figure. Tighten the 2 brake caliper bracket mounting bolts to specification. See TORQUE SPECIFICATIONS .
  7. Install the quarter shaft shield. See Figure.
  8. Install the quarter shaft shield nut and the bolt. Tighten the quarter shaft shield nut and the bolt to specification. See TORQUE SPECIFICATIONS .
  9. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
  10. Lower the vehicle.
  11. With the engine OFF gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  12. Slowly release the brake pedal.
  13. Wait 15 seconds then repeat steps  6- 8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
scientia non olet · About LEMON Manuals