LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Disc Brakes) >> Removal & Installation >> Brake Pads >> Removal (Front)

Removal (Front)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the fluid level in the brake master cylinder reservoir. See Figure.
  2. If the brake fluid level is midway between the maximum--full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
  3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the midway point before proceeding.
  4. Raise and support the vehicle.
  5. Remove the tire and wheel assembly.
  6. Inspect the caliper operation. See BRAKE CALIPER INSPECTION  under ADJUSTMENTS & INSPECTION.
  7. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. See BRAKE CALIPER .
  8. Remove the brake pads from the caliper mounting bracket.
  9. Remove and discard the anti-rattle clips from the brake caliper mounting bracket.
  10. Inspect the caliper and mounting bracket. See BRAKE CALIPER INSPECTION  under ADJUSTMENTS & INSPECTION.
scientia non olet · About LEMON Manuals