LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Disc Brakes) >> Removal & Installation >> Brake Pads >> Installation (Rear - All Except 1500 Series Without 4-Wheel Steering)

Installation (Rear - All Except 1500 Series Without 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the anti-rattle clips to the brake caliper mounting bracket. See Figure.
  2. Install the disc brake pads to the brake caliper mounting bracket.
  3. Install the brake caliper to the brake caliper mounting bracket. See BRAKE CALIPER .
  4. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
  5. Remove the safety stands.
  6. Lower the vehicle.
  7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  8. Slowly release the brake pedal.
  9. Wait 15 seconds, then repeat steps  7- 8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  10. Fill the master cylinder reservoir to the proper level with clean brake fluid. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING BRAKE SYSTEM.
  11. Burnish the brakes pads and rotors as necessary. See BURNISHING PADS & ROTORS  under SERVICING.
scientia non olet · About LEMON Manuals