LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Disc Brakes) >> Removal & Installation >> Brake Hose >> Installation (Rear - Jounce)

Installation (Rear - Jounce)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear brake hose. See Figure.
  2. Install the junction block retaining bolt to the axle. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
  3. Remove the caps or plugs from the rear brake pipes and connect the pipes to the junction block on the axle. Tighten the fitting to specification. See TORQUE SPECIFICATIONS .
    NOTE: The hose must not be twisted. Make sure the hose is not in contact with any suspension component.
  4. Install the brake hose into the bracket.
  5. Install the jounce hose retaining clip.
  6. Remove the rubber cap or plug from the exposed brake pipe fitting end.
  7. Connect the brake pipe fitting to the brake hose. Use a backup wrench on the hose fitting. Do not bend the bracket or the pipe. Tighten the fitting to specification. See TORQUE SPECIFICATIONS .
  8. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
  9. Bleed the hydraulic brake system. See BLEEDING BRAKE SYSTEM .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals