Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Install the right secondary camshaft drive chain by sliding the chain down through the right cylinder head and placing the chain on the right intake camshaft sprocket.
- Route the right secondary camshaft drive chain around the outer row of the camshaft intermediate drive shaft sprocket teeth.
- Install the right exhaust camshaft sprocket into the right secondary camshaft drive chain.
- Install the right exhaust camshaft sprocket onto the camshaft. The camshaft sprocket notch marked RE (right exhaust) engages the exhaust camshaft pin.
- Use an open end wrench on the hex cast into the camshaft in order to prevent the camshaft from rotating when tightening the camshaft sprocket bolt.CAUTION: Refer toFASTENER NOTICE .
- Install the right exhaust camshaft sprocket bolt.
Tighten
Tighten the camshaft sprocket bolt to 120 N.m (89 ft lbs).
- Install the right secondary camshaft drive chain tensioner. Refer to Secondary Camshaft Drive Chain Tensioner Replacement - Right .
- Remove the J 44212 from the camshafts.
- Install the right camshaft cover. Refer to Camshaft Cover Replacement - Right .
- Install the camshaft position sensor. Refer to CAMSHAFT POSITION SENSOR .