Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Position the flywheel and the reinforcement to the crankshaft.
- Apply sealant, GM P/N 12346004 or equivalent, to the flywheel mounting bolts.CAUTION: Refer toFASTENER NOTICE .
- Install the eight NEW mounting bolts.
- 3.1. First Pass
Tighten
Tighten the flywheel mounting bolts to 15 N.m (11 ft lbs).
- 3.2. Final Pass
Tighten the flywheel mounting bolts an additional 50 degrees using the J 36660-A .
- 3.1. First Pass
- Install the transaxle assembly. Refer to TRANSAXLE (4T80-E) .