LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Engine Controls - Removal & Installation) >> Sensors >> Crankshaft Position Sensor >> Removal (2.2L)

Removal (2.2L)

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft Position (CKP) sensor is located on side of block, behind starter. See Fig 1 . Disconnect the negative battery cable.
  2. Raise and support the vehicle.
  3. Disconnect the electrical connectors from the starter.
  4. Remove the starter bolts. Remove the starter. See Fig 2 .
  5. Disconnect the Crankshaft Position (CKP) sensor harness connector.
  6. Remove the CKP sensor bolt. Remove the CKP sensor.
Fig 1: Locating Crankshaft Position Sensor (2.2L)
G00121071Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Starter (2.2L)
G00217362Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals