LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Engine Controls - Removal & Installation) >> Motors & Solenoids >> EVAP Canister Vent Solenoid >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
  1. The EVAP canister vent solenoid is located underneath vehicle. See Fig 1 . Raise and support the vehicle.
  2. Loosen the EVAP canister vent valve hose clamp and slide the clamp down the hose away from the EVAP vent valve hose connection. See Fig 2 .
  3. Remove the hose from the EVAP canister vent valve.
  4. Remove the EVAP canister vent valve by placing a pry bar between the valve and mounting surface, and moving the valve forward. See Fig 3 .
  5. Remove the clip from the EVAP canister vent valve harness connector. See Fig 4 .
  6. Disconnect the EVAP canister vent valve harness connector. See Fig 5 .
Fig 1: Locating EVAP Canister & Vent Solenoid
G00121074Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Vent Valve Hose
G00217353Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing/Installing EVAP Canister Vent Valve
G00217354Courtesy of GENERAL MOTORS CORP.
Fig 4: Removing/Installing EVAP Canister Vent Valve Harness Connector
G00217355Courtesy of GENERAL MOTORS CORP.
Fig 5: Disconnecting EVAP Vent Valve Harness Connector
G00217356Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals