LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 251 (Engine Controls - Removal & Installation) >> Ignition Systems >> Ignition Coil Housing (2.2L) >> Removal

Ignition Coil Housing (2.2L): Removal

WARNING: This page is about a different car, the 2003 Pontiac Grand Am and 2003 Oldsmobile Alero. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Numbers in parenthesis correspond to numbered components in referenced illustrations.
  1. Turn ignition switch to OFF position. Remove the air cleaner outlet resonator, air cleaner intake duct and vent hose.
  2. Disconnect the cruise control cable (2) from the throttle body (3) and the accelerator bracket (1). See Figure .
  3. Disconnect the cruise control cable (2) from the throttle body (3) and the accelerator bracket (1). See Figure .
  4. Remove the 2 accelerator bracket nuts (3). See Figure .
  5. Remove the accelerator bracket (2) from the throttle body (1). See Figure .
  6. Disconnect Ignition Control Module (ICM) harness connector. See Fig 1 .
  7. Remove ICM retaining screws. Remove ICM from ignition coil housing. See Figure .
  8. Remove ignition coil housing retaining bolts. Remove ignition coil housing from camshaft cover.
Fig 1: Removing/Installing Ignition Coil Housing & Ignition Control Module (2.2L)
G00112750Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals