LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Disc Brakes) >> Removal & Installation >> Park Brake Pedal Assembly >> Removal

Park Brake Pedal Assembly: Removal

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix and 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Special Tool Required: Parking Brake Cable Release Tool (J-37043) & Door Trim Pad Remover (J-38778).
  1. Remove the left side instrument panel insulator.
  2. Remove the left carpet retainer. Use the door trim pad remover to remove the left and/or right front carpet retainer. Use the door trim pad remover to remove the left and/or right front pillar, lower trim panel.
  3. Pull back the carpet for access.
  4. Raise and suitably support the vehicle.
  5. Relieve cable tension from the park brake system at the equalizer.
  6. Disconnect the front cable from the rear cable at the connector clip. See Figure .
  7. Lower the vehicle.
  8. Disconnect the electrical connector at the park brake switch.
  9. Remove the 3 park brake pedal assembly retaining nuts from the body mounting studs.
  10. Remove the retaining clip and disconnect the park brake cable from the park brake pedal assembly. See Figure .
  11. Use the park brake cable release tool in order to remove the cable from the pedal assembly. Remove the park brake pedal assembly.
scientia non olet · About LEMON Manuals