LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Disc Brakes) >> Removal & Installation >> Park Brake Pedal Assembly >> Installation

Park Brake Pedal Assembly: Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix and 2002 Oldsmobile Intrigue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake pedal assembly.
  2. Connect the park brake cable to the park brake pedal assembly and install the retaining clip. See Figure .
  3. Install the 3 park brake pedal assembly retaining nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS  .
  4. Connect the electrical connector to the park brake switch.
  5. Raise and suitably support the vehicle.
  6. Connect the front cable to the rear cable at the connector clip. See Figure .
  7. Adjust the park brake system. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
  8. Lower the vehicle. Position the carpet in place.
  9. Install the left and/or right front lower pillar, trim panel. Apply pressure until the panel is fully seated. Install the left and/or right front door carpet retainer. Apply pressure until the carpet retainer is fully seated.
  10. Install the left side instrument panel insulator.
scientia non olet · About LEMON Manuals