LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 243 (Engine Control System - Removal & Installation) >> Sensors & Switches >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Park/Neutral Position (PNP) switch is located on side of transaxle. Remove the battery.
  2. Remove 4 battery tray retaining bolts. Remove the battery tray from the vehicle.
  3. Remove the shift cable retaining clip. See Fig 1 .
  4. Disconnect the cable from the bracket.
  5. Remove the shift cable retaining nut, then disconnect the cable from the manual lever. See Fig 1 .
  6. Disconnect the PNP switch harness connector (1). See Fig 2 .
  7. Remove nut and lock washer and the manual lever from the manual shaft. See Fig 3 .
  8. Unstake the lock plate (1) behind the manual shaft nut (3). See Fig 3 .
  9. Remove the manual shaft nut and the lock plate from the PNP switch.
  10. Remove 2 PNP switch mounting bolts (2) and the PNP switch from the transaxle.
Fig 1: Identifying Shift Cable Retaining Clip
G00180674Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing/Installing Park/Neutral Position Switch
G00180675Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing/Installing Park/Neutral Position Switch
G00180676Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals