If Shudder Occurs After TCC Has Applied

If shudder occurs after the TCC has applied, most of the time there is nothing wrong with the transaxle.

As mentioned above, the TCC is not likely to slip after the TCC has been applied. Engine problems may go unnoticed under light throttle and load, but they become noticeable after the TCC apply when going up a hill or accelerating. This is due to the mechanical coupling between the engine and the transaxle.

Once TCC is applied, there is no torque converter (fluid coupling) assistance. Engine or driveline vibrations could be unnoticeable before TCC engagement.

Inspect the following components in order to avoid misdiagnosis of TCC shudder. An inspection will also avoid the unnecessary disassembly of a transaxle or the unnecessary replacement of a torque converter.

1. Spark Plugs
   
   Inspect for cracks, high resistance or a broken insulator.
2. Plug Wires
   
   Look in each end. If there is red dust (ozone) or a black substance (carbon) present, then the wires are bad. Also look for a white discoloration of the wire. This indicates arcing during hard acceleration.
3. Coil
   
   Look for a black discoloration on the bottom of the coil. This indicates arcing while the engine is misfiring.
4. Fuel Injector
   
   The filter may be plugged.
5. Vacuum Leak
   
   The engine will not get a correct amount of fuel. The mixture may run rich or lean depending on where the leak occurs.
6. EGR Valve
   
   The valve may let in too much or too little non-combustible exhaust gas and could cause the engine to run rich or lean.
7. MAP/MAF Sensor
   
   Like a vacuum leak, the engine will not get the correct amount of fuel for proper engine operation.
8. Carbon On The Intake Valves
   
   Carbon restricts the proper flow of air/fuel mixture into the cylinders.
9. Flat Camshaft
   
   Valves do not open enough to let the proper fuel/air mixture into the cylinders.
10. Oxygen Sensor
    
    This sensor may command the engine too rich or too lean for too long.
11. Fuel Pressure
    
    This may be too low.
12. Engine Mounts
    
    Vibration of the mounts can be multiplied by TCC engagement.
13. Axle Joints
    
    Check for vibration.
14. TP Sensor
    
    The TCC apply and release depends on the TP sensor in many engines. If the TP sensor is out of specification, TCC may remain applied during initial engine loading.
15. Cylinder Balance
    
    Bad piston rings or poorly sealing valves can cause low power in a cylinder.
16. Fuel Contamination
    
    This causes poor engine performance.