Accumulator & 2-1 Manual Servo: Installation
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The seal must be installed as shown. If it is not installed, or is installed in the wrong location, the transaxle will operate only in reverse.
- Install the 2-1 manual servo piston assembly and the filter.
- Install the accumulator assembly. See Figure .
- Install the manual 2-1 band servo cover bolts. Tighten the manual 2-1 band servo cover bolts to specification. See TORQUE SPECIFICATIONS .
- Install the accumulator attaching bolts. Tighten the accumulator attaching bolts to specification. See TORQUE SPECIFICATIONS .
- Install the new filter seal. Install the filter.
- Lower the vehicle.