Installation (Front Door - Impala)
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Use correct fastener in correct location. Replacement fasteners must be correct part number for application. Fasteners requiring replacement or fasteners requiring use of thread locking compound or sealant are identified in service procedures. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage fastener. Use correct tightening sequence and specifications when installing fasteners in order to avoid damage to part and systems.
- Install power door lock switch to inside door handle bezel pressing into place until fully seated. Install door armrest pull cup to front inner door trim panel pressing into place until fully seated. Before installing door trim panel to door inner panel, old trim panel retainers must be discarded and replaced with NEW trim panel retainers.
- Align door water deflector to door inner panel. Secure water deflector at corners. Pull door wiring harness leads through slits in door water deflector. Install door water deflector, start pressing adhesive pattern at bottom center and working outward and upward in order to prevent puckering.
- Install door lock screws in proper tightening sequence. See Fig 1 . Install a NEW outside handle rod-to-lock clip onto door lock lever. Position door outside door handle rod in clip to eliminate any free play in door outside door handle. Install clip cover closed over threaded door outside door handle rod. Install clip to door inside handle rods. Install door handle rods to handle. To complete installation, reverse removal procedure.