LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1727 (Wiring Systems (General Information)) >> Diagnostic Information & Procedures >> Probing Electrical Connectors >> Frontprobe

Probing Electrical Connectors: Frontprobe

WARNING: This page is about a different car, the 2001 Chevrolet Monte Carlo and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the connector and probe the terminals from the mating side (front) of the connector.

NOTE: Do not  insert test equipment probes into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A deformed terminal can cause a poor connection, which can result in system failures. Always use the J 35616-A Connector Test Adapter Kit or the J 42675 Flat Wire Probe Adapter Kit in order to frontprobe terminals. Do not  use paper clips or other substitutes as they can damage terminals and cause incorrect measurements.