Engine Front Cover Assemble

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

EN-46103 Camshaft Actuator Valve Seal Remover/Installer. See Special Tools .
J 29184 Output Shaft Seal Installer. See Special Tools .

Fig 1: Installing Crankshaft Front Oil Seal

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not lubricate the crankshaft front oil seal or crankshaft balancer sealing surfaces. The crankshaft balancer is installed into a dry seal.

Install the NEW crankshaft front oil seal into the engine front cover using the J 29184 . See Special Tools .

Fig 2: View Of Piston Notches

Courtesy of GENERAL MOTORS CORP.

Place the seal into position with the notches (1) in the seal down. The notches (1) will face inboard when properly installed.

Fig 3: Installing camshaft position actuator valve oil seals

Courtesy of GENERAL MOTORS CORP.

Install the NEW camshaft position actuator valve oil seals into the engine front cover using the EN-46103 . See Special Tools .