Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate HO2S 1.
- Connect a 3 A fused jumper wire between the reference voltage circuit terminal 6 and low reference circuit terminal 2.
- Ignition ON, test for greater than 1 volt between the pump current circuit terminal 5 and ground.
- If less than the specified range, test the pump current circuit for an open. If the circuit tests normal, replace the ECM.
- If all circuits test normal, replace the appropriate HO2S 1.