Circuit/System Testing
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, open the hood to disable the Auto-Stop function.
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to DTC P254F .
- Ignition OFF, disconnect the harness connector at the appropriate HO2S.
- Ignition ON, verify that the HO2S parameter is between 350-500 mV.
- If greater than 500 mV, test the signal circuit of the HO2S sensor for a short to the heater circuit. If the circuit/connections test normal, replace the ECM.
- If all circuits/connections test normal, replace the applicable HO2S.